RAISED KERB INTERNAL CORNER

STEP 1

Create an effective corner (ready for Raised Kerb Trim Internal Corners to be fitted) by butt-joining two lengths of Raised Kerb Trim where they meet at an internal right angle.

Make sure to leave a 4mm expansion gap.

STEP 2

If necessary, carefully remove any excess foam seal.

STEP 3

Apply super glue to ONE inside edge of the Raised Kerb Trim Internal Corner component.

(Only one side is superglued to allow for any expansion of the joined lengths of Raised Kerb Trim.)

STEP 4

Apply uPVC superglue activator to the Raised Kerb Trim corner area where the superglued inside edge of the Internal Corner component is to be affixed.

STEP 5

Firmly press the Internal Corner component down and into the Raised Kerb Trim butt-joined corner and hold in place until adhesion is solid.