GUTTER DRIP EXTERNAL CORNER
Training hub – all your questions answered!
For the best results, please follow the instructions below.
STEP 1
Create an effective corner (ready for Gutter Trim External Corners to be fitted) by butt-joining two lengths of Gutter Trim where they meet at an external right angle.
Make sure to leave a 4mm expansion gap.
STEP 2
Apply super glue to ONE inside edge of the Gutter Trim Corner component.
(Only one side is superglued to allow for any expansion of the joined lengths of Gutter Trim.)
STEP 3
Apply uPVC superglue activator to the corner area where the superglued inside edge of the External Corner component is to be affixed.
STEP 4
Firmly press the External Corner component down and into the gutter trim and hold in place until adhesion is solid.
Bonus Step
How to join Integra Trim Gutter Trim to Integra Trim Raised Kerb Trim at an external corner.
Where Gutter Trim meets Raised Kerb Trim at an external corner, corner fittings incorporating both trim types must be created.
Butt-join each length of trim as usual and use Raised Kerb Trim Corner components to join them following the steps above (making sure to only snap-out the Raised Kerb Trim side of the corner component).
