EPDM Roofing Calculator

FIXING THE EPDM RUBBER ROOF MEMBRANE – SHED RUBBER

Training hub – all your questions answered!

For the best results, please follow the instructions as detailed below.
If you still have questions please feel free to contact us using the form here…

STEP 1

Fold back half of the EPDM Rubber Roof Membrane onto itself to expose the timber deck underneath.

Apply the WBA Deck Adhesive evenly over the roof deck with the Roller supplied.

With the adhesive still wet, roll the membrane back into position using a soft broom to ensure no air is trapped underneath the membrane and to ease out any creases.

Repeat the process for the other half of the roof.

shed kit installation epdm flat rubber roofing step2 | Rubber Roofing Direct
shed kit installation epdm flat rubber roofing step3 | Rubber Roofing Direct

STEP 2

Cut off any excess EPDM Rubber Roof Membrane using sharp scissors or a knife leaving approximately 50mm overhang.

STEP 3

Fold the membrane back on itself and fix using galvanised clout nails.

Note: As an alternative you could install black metal shed edge trims which are available on our website

If you encounter any problems whilst carrying out your installation or you need some advice, please contact us to speak to an experienced installer.

shed kit installation epdm flat rubber roofing step4 | Rubber Roofing Direct