Video Training
  • Tools & Equipment
  • Precautions
  • Hammer
  • Pencils
  • Safety glasses
  • Tape Measure
  • Superglue
  • Hand saw

Be careful when using superglue not to overspill as it cannot be cleaned from the Sure Edge or EPDM Rubber Roofing products.

Only apply glue to one side of the Sure Edge joining trims to prevent expansion and contraction from fracturing the Sure Edge product.

When hammering in polytop pins to secure the Sure Edge flat roof trims, use a direct hammering action to prevent slippage from the pin head resulting in denting to the Sure Edge flat roof trims.

Extreme care must be exercised when working on ladders, roofs, or at elevations above ground. If used as an emergency repair to a roofing system, contact the roofing system manufacturer for compatibility and to ensure compliance with terms and limitations of the warranty.

Surface can be slippery when wet, damp, or frost covered.

Do not expose product to temperatures in excess of 82° C (180°F).

This product is not intended for use where roof top traffic or activity is anticipated without a protective layer installed on its surface.

Step 1

 

Position the check kerb trims in place and remove excess foam.

Step 2

 

Apply Super Glue to the inside edge that will be contact with one side of Check Kerb trim

Step 3

 

Apply activator to the Check Kerb trim and push corner into posistion.

Step 4

 

Apply and hold the corner piece firmly in place until secure.