With the coping stone removed, bond the membrane over the parapet wall leaving a 30 mm gap from the external wall face, seal the membrane edge onto a bead of water block mastic
Bed the coping stones over the parapet wall using a tough sand and cement mortar mix of at least 3 and 1 ratio with added PVA adhesive for extra strength.
Note: EPDM expands in hot weather and can crack weak mortar.
STEP 1 Cut down the roof drain leaving a 50 mm equal flange the whole way around, drop the roof... read more
STEP 1 Cut down the roof drain leaving a 50 mm equal flange the whole way around, drop the roof... read more
STEP 1 Ensure that the membrane around the external corner is clean, dry and free from dust or debris. Using... read more
The prepared roof surface must be clean, dry, free from dust, and contaminants (bitumen, oil etc). Do not attempt... read more
STEP 1 Form the membrane into a 45 degree (pig’s ear) shape where the membrane meets in the internal corner. STEP... read more
STEP 1 Fold back half of the EPDM Rubber Roof Membrane onto itself to expose the timber deck underneath. Apply the... read more
Only carry out this installation on a dry day where temperatures are above freezing! Included in your Rubber Roof Shed... read more
STEP 1 Overlap the FlexiProof EPDM membrane onto the adjoining flat roof system by 60 mm. STEP 2 Lift up the FlexiProof... read more
STEP 1 Pull the pipe flashing firmly over the top of the pipe. Locate the ribbed band directly above the... read more
STEP 1 Unroll the FlexiProof EPDM membrane over the substrate so that the sheet is in the desired position. Carefully open... read more
© Copyright 2021 Rubber Roofing Direct. All rights reserved.
Registered in England Company Number: 09132601. VAT Number. 196779235
