£15 OFF ORDERS OVER £400+VAT PROMOCODE "SEPTEMBER22" VALID TILL 31/09/2020
Simplify your next EPDM installation with the One Part Pourable Sealer.
One Part Pourable Sealer is a single component, moisture curing, elastomeric polyether sealant that is compatible with EPDM membranes. The material is designed to provide a flexible, durable and long lasting seal around hardto-flash penetrations and roofing details. One Part Pourable Sealer provides rapid skin time when exposed to atmospheric moisture forming a waterproof rubber surface in less than one (1) hour. Moisture curing continues, until a two (2) – inch deep solid rubber seal encases the penetration. Complete cure time will vary depending on relative humidity and temperature.
The sealant’s one-part, pourable consistency allows for quick sealing without mixing.
EPDM Primer must be applied to all surfaces, including cured membrane and uncured flashing that will be in contact with One Part Pourable Sealer. Unused sealant remaining in a pouch will remain useable up to 30 days if pouch is resealed with original cap.
One Part Pourable Sealer is designed to provide a flexible, durable and long lasting seal around hard-to-flash penetrations and roof details.
Features and Benefits
• Ready to use - no mixing required
• Pouch can be resealed with original cap
• Provides a flexible, durable and long lasting seal around hard to flash penetrations
• Provides a water-tight seal in less than one hour
One 2 litre pouch will fill 122 cubic inches of volume within a sealer dam.