5ft x 7ft Apex Shed Roof Kit (2m x 2.4m)
£60.34 ex VATReplace your shed roof once and for all. Our quick and easy-to-install replacement rubber roof kits are the ideal solution for long-term waterproofing of your shed roof.
- Description
- Additional information
- Installation
Description
Sheds are an important part of our home, often storing expensive equipment like mowers and strimmer’s. Yet, all too often, they rely on cheap, thin felt to keep them weather-tight. Well, not any more! We have standard size rubber roofing shed roof kits compromised EPDM Rubber roofing membrane sheet and the adhesive to complete the job.
- Shed Kit Contains
2m x 2.4m of 1.14mm Shed Rubber EPDM Membrane Sheet
Water Based Deck Adhesive and an adhesive roller
Instructions
Our Rubber Roof Kits are designed to fit standard garden shed sizes. Whilst we have allowed enough excess membrane to the width and length, please check the sizes against your own shed as sizes differ between shed manufacturers.
Additional information
Weight | 11 kg |
---|---|
Dimensions | 0.8 × 0.3 × 0.3 m |
Brand | Shed Rubber |
- Carefully remove the existing timber edge trims (fascias).
- Put them to one side if they are in good condition so you can re-fit them later.Remove the old roof covering (usually felt), remove any exposed nails, all sharp surfaces and repair/replace any rotten deck boards.
- We recommend using OSB3 board if you need to fully replace them.
- Ensure that your deck surface is clean, dry, frost-free, and free from dust, grease, loose material, and other contaminants. Unwrap the EPDM Rubber Roof Membrane and place it unfolded on the shed roof, ensuring equal coverage. Wait for approximately half an hour for the EPDM to relax.
- Fold back half of the EPDM membrane onto itself to expose the timber deck underneath. Apply the WBA Deck Adhesive evenly over the roof deck with the Roller supplied. With the adhesive still wet, roll the membrane back into position using a soft broom to ensure no air is trapped underneath the membrane and to ease out any creases. Repeat the process for the other half of the roof.
- Cut off any excess EPDM Rubber Roof Membrane using sharp scissors or a knife, leaving approximately 50mm overhang. Fold the membrane back on itself and fix using galvanised clout nails or with a timber batten.